Promx
KTM50 SX, 50 SX MiniEasy30 min

KTM 50 SX: brake pad replacement

Replace worn brake pads on a KTM 50 SX safely – covers both front and rear brakes.

Worn brake pads increase stopping distance and can damage the brake disc. On a KTM 50 SX, pad replacement is a home-garage job with basic tools – this guide covers both front and rear brakes.

Before you start

Safety: never touch the disc or caliper pistons with greasy fingers. If a brake line is opened, the brakes must be bled – this guide pushes the pistons back without opening any lines. Always check torque values in the owner's or repair manual.

  • Let the bike cool down and put it securely on a stand.
  • Clean around the caliper so dirt cannot enter the brake system.

Replacing the rear pads

  1. Remove the rear caliper pad pins and retaining clips by loosening the caliper hardware.
  2. Carefully press the caliper piston back – for example with a clean screwdriver or a piston press tool. Check that the fluid reservoir does not overflow.
  3. Pull out the old pads and compare them with the new ones: same shape and size.
  4. Clean the caliper and the pad slide surfaces with brake cleaner.
  5. Fit the new pads, reinstall the pins and secure them as the manual specifies.
  6. Pump the brake pedal several times until it feels firm.

Replacing the front pads

  1. Remove the front caliper pad pins and retainers.
  2. Press the pistons back into the caliper the same way.
  3. Swap the pads, clean the slides and refit the pins.
  4. Pump the front brake lever until pressure builds – otherwise there will be no brake on the first pull.

Tips

  • Check the brake fluid level and condition at the same time – dark fluid should be replaced.
  • Bed in new pads by braking gently first and increasing load gradually.
  • If the disc is warped or grooved, consider replacing it too.
  • Use copper-based pad grease only where the manufacturer recommends it.

Read also