Promx
GASGASMC 50Intermediate40 min

GASGAS MC 50: brake fluid change and bleeding

Old brake fluid absorbs moisture and ruins lever feel – change and bleed it correctly.

Brake fluid absorbs moisture over time – old fluid boils more easily and makes the lever spongy. Changing and bleeding the fluid on an MC 50 requires care but is doable with these steps.

Before you start

Safety: brake fluid damages paint and plastics – cover the bike and wipe spills immediately. Always use fresh fluid of the correct DOT grade per the manual. Never let the master cylinder reservoir run dry.

  • Put the bike securely on a stand.
  • Cover the handlebar, plastics and painted surfaces.

Draining and bleeding

  1. Fit the bleed hose onto the bleed nipple and run the other end into a container.
  2. Open the master cylinder cap and top up with fluid.
  3. Pump the lever, hold it down and open the nipple – close it before releasing the lever. Repeat until the fluid runs clear.
  4. Keep topping the reservoir; never let air into the system.
  5. When new fluid flows clear, close the nipple to the manual's torque and refit the dust cap.

Check

  1. Pump the lever several times – the feel must be firm, not spongy.
  2. Check the fluid level and for leaks at the caliper and master cylinder.
  3. Test first at walking pace.

Tips

  • If air cannot be removed conventionally, try pressure bleeding or a dedicated bleeder.
  • Change the fluid seasonally – more often in racing use.
  • Note the change date in the service log.

Read also