Promx
GASGASMC 85Intermediate60 min

GASGAS MC 85: clutch plate replacement

A slipping clutch wastes power – replacing the clutch plates on the MC 85 is a home-garage job.

The MC 85 clutch works hard – under racing and practice loads the plate friction wears and the clutch starts to slip or drag. Replacing the plate set takes about an hour for a first-timer, and it is a good time to inspect the clutch basket.

Before you start

Safety: remove the spark plug cap before working and make sure the bike cannot start accidentally. Always check clutch spring and bolt torques in the manual. Note the plate order before disassembly.

  • Drain the gearbox oil or lay the bike on its side so oil does not spill when the cover comes off.
  • Clean around the clutch cover.

Cover and old plates

  1. Remove the clutch cover and its gasket – buy a spare gasket beforehand.
  2. Loosen the clutch spring bolts evenly in a cross pattern, remove the pressure plate and the plates.
  3. Keep the plates in order: take a photo or note how friction and steel plates alternate.
  4. Inspect the clutch basket: notches worn into the fingers can require filing or a new basket.

Fitting the new plates

  1. Soak the new friction plates in gearbox oil as the manual specifies.
  2. Install the plates in the same order as the old ones – friction and steel plates alternating.
  3. Refit the pressure plate and springs; tighten the bolts in a cross pattern to spec.
  4. Check the free play at the lever and adjust if needed.
  5. Fit a new gasket and cover, refill with gearbox oil.

Tips

  • Replace the springs at the same time if they are short or warped.
  • After a test ride, re-check the clutch feel – the plates settle slightly.
  • Basket notches may hide wear; check them before refitting.

Read also

GASGAS MC 85: clutch plate replacement | Promx