GASGAS MC 85: piston and piston ring replacement
A two-stroke piston is a wear part – regular replacement protects the cylinder and crank.
The MC 85 piston and rings wear every season – regular replacement is cheap insurance for the engine's most expensive part. The job demands care and cleanliness, and takes a first-timer about two hours.
Before you start
Safety: top-end work on a two-stroke requires care – one wrongly seated ring clip or a forgotten gasket scrap can wreck the engine. Photograph every step and mark the orientation of parts. Check all torques in the manual.
- Let the engine cool and remove the required panels and hoses.
- Check engine hours – piston life is in the manual or set after a fixed interval.
Removing the cylinder and piston
- Undo the cylinder fixings and lift the cylinder straight up.
- Remove the piston rings after noting them – mind their direction and locating pins.
- Remove the piston pin circlips and push the pin out; keep the needle bearing in place.
- Measure the cylinder: bore size and taper are given in the manual tolerances.
Fitting the new piston
- Lightly oil the pin and needle bearing with two-stroke oil.
- Fit the piston in the manual's direction – usually with the arrow to the exhaust side.
- Lock the pin with new circlips – never reuse the old ones.
- Fit the rings the right way up and align them with the locating pins.
- Lightly hone and clean the cylinder, oil it and lower it over the new gasket.
- Tighten the cylinder nuts to the manual's torque and sequence.
Running in and checks
- Fill the tank with fresh fuel at the manual's ratio.
- Run the engine at idle first, then build load gradually over a few tanks.
- After the first ride, check the plug and listen for unusual noises.
Tips
- Buy all gaskets in advance – old ones often tear during disassembly.
- Keep the work area clean: grit on a new piston ruins a cylinder fast.
- Record the change hours in the service log and set the next reminder.