Promx
KTM65 SXIntermediate45 min

KTM 65 SX: chain and sprocket replacement

A worn drivetrain eats power and can let you down – always replace the chain and sprockets as a set.

The chain and sprockets wear together – a new chain on old sprockets wears out in no time, so always replace the parts as a set. Swapping the drivetrain on a KTM 65 SX takes about 45 minutes for a first-timer.

Before you start

Safety: a chain tool requires accuracy – a poorly riveted master link can come off while riding. Check all torque values in the manual. Remove the spark plug cap or use the rear brake to lock the wheel.

  • Put the bike on a stand and make sure the rear wheel spins freely.
  • Note the chain adjuster settings so the axle alignment stays correct.

Removing the old drivetrain

  1. Remove the master link spring clip and links – use a chain tool or cut the old chain off.
  2. Undo the rear sprocket nuts and the front sprocket retainer – the rear sprocket may need the rear wheel braked.
  3. Remove the old sprockets and compare with the new: tooth profile, tooth count and bolt pattern.

Fitting the new parts

  1. Fit the front sprocket the correct way round and secure it per the manual.
  2. Bolt the rear sprocket on – tighten the nuts in a star pattern to the correct torque.
  3. Loop the new chain over the sprockets and rivet the master link: the closed end of the clip faces the direction of travel.
  4. Adjust chain tension to spec – an over-tight chain damages bearings and the drivetrain.
  5. Align the axle with the swingarm marks and tighten the axle nut.

Tips

  • Lubricate the new chain before the first ride – it usually only carries shipping grease.
  • Check the chain guide and slider at the same time: a worn guide pushes the chain off-line.
  • A new drivetrain needs breaking in: run the first tank under moderate load.

Read also

KTM 65 SX: chain and sprocket replacement | Promx