Promx
KTM65 SXEasy20 min

KTM 65 SX: air filter cleaning and oiling

A clean, correctly oiled air filter is the most important service job on a two-stroke – here is how to do it right.

A dirty air filter lets sand and dust straight into the cylinder – on a two-stroke it is the fastest way to ruin a piston and bore. The KTM 65 SX filter comes off without tools and takes only minutes to service.

Before you start

Safety: never run the engine without a filter or with a poorly seated one. Some dry oils can clog the carburettor – always use oil made for foam filters. Work in a well-ventilated area.

  • Remove the seat or airbox cover depending on the model.
  • Seal the intake boot with a wash cover or a clean plug.

Removing and inspecting the filter

  1. Release the filter retainer and lift the filter out carefully.
  2. Check the filter for tears, holes and loose glue seams – a damaged filter must always be replaced.
  3. Wipe the airbox clean with a rag – do not push the rag into the intake boot.

Washing and drying

  1. Soak the filter in filter cleaner or diesel and squeeze the dirt out – do not wring or twist the foam, as the seams can split.
  2. Wash a second time if needed and rinse finally in soapy water.
  3. Let the filter dry completely – no hair dryer or direct heat, as the foam can be damaged.

Oiling and refitting

  1. Apply filter oil evenly over the whole filter; squeeze until the oil is uniform and excess is removed.
  2. Lightly grease the sealing edge that touches the airbox.
  3. Refit the filter, check the edge is not folded and lock the retainer.
  4. Remove the wash cover or plug and refit the seat.

Tips

  • On sandy tracks or in dry dust, service the filter after every riding day.
  • A pre-oiled spare filter and a wash cover save time on practice days.
  • Note the service interval – consistency matters more than any brand of product.

Read also