Promx
HusqvarnaTC 65Easy15 min

Husqvarna TC 65: chain tensioning and lubrication

A correctly tensioned and lubricated chain lasts longer and transfers power cleanly.

The chain is the hardest-working part on a youth bike – too loose it can jump the sprocket, too tight it eats bearings and transmission. Chain tensioning and lubrication on a TC 65 belong in every riding day's routine.

Before you start

Safety: the correct free play is in the manual – do not guess. Always tension from the chain's tightest spot, as chains wear unevenly. Working on a cold bike is safer.

  • Put the bike on a stand and spin the rear wheel by hand.
  • Find the tightest spot by turning the wheel a full revolution.

Tensioning the chain

  1. Loosen the rear axle nut so the axle can move.
  2. Adjust the tensioner bolts evenly on both sides – check wheel alignment against the marks.
  3. Measure free play between the lower run and the chain at the manual's point.
  4. Tighten the axle nut to spec and re-check tension.

Lubrication

  1. Clean the chain if needed with chain cleaner and a brush – do not use a wire brush on O-rings.
  2. Wipe the chain dry.
  3. Apply chain lubricant evenly along the whole chain while spinning the wheel.
  4. Let the lube tack for a moment before riding.

Tips

  • Lubricate the chain after riding while it is still warm – the lube penetrates better.
  • Check the slider and guide surfaces along with chain condition.
  • If the chain kinks or binds, consider replacement – see the chain and sprocket guide.

Read also