Promx
HusqvarnaTC 50Intermediate45 min

Husqvarna TC 50: carburettor cleaning

A dirty carb causes running problems – thorough cleaning restores mixture control.

The TC 50 carburettor is small and precise – dirt or old fuel clogs the jets and causes rough running. Cleaning the carb is a routine job worth doing at the start of the season and after storage.

Before you start

Safety: work in a ventilated area with no open flames or sparks. Small parts are easily lost – use a tray or magnetic pan. Note the routing of hoses and cables before removal. Fuel can damage skin and paint.

  • Turn off the fuel tap and drain the carb via the bottom screw.
  • Remove the fuel line and throttle cable.

Disassembling the carburettor

  1. Remove the carb from the intake boot and exhaust outlet.
  2. Note the positions of jets and parts – photograph the disassembly.
  3. Remove the float chamber, jets, needle valve and floats.
  4. Lay small parts on a tray in order.

Cleaning and reassembly

  1. Wash the carb and parts in carburettor cleaner – make sure every passage is clear.
  2. Blow the passages clean with compressed air.
  3. Inspect the needle valve and floats: worn or damaged parts are replaced.
  4. Reassemble in the original order and check the floats move freely.
  5. Refit the carb, attach hoses and cables and set the mixture screw to the manual's position.

Starting and tuning

  1. Open the fuel tap and let the carb fill.
  2. Start and warm the engine, then set the idle and mixture screws per the manual.
  3. Check for leaks at the hoses and joints.

Tips

  • Use fresh fuel – old petrol is the most common cause of carb problems.
  • Keep carb cleaner away from plastics and paint.
  • Record the original screw settings before adjusting so you can return if needed.

Read also