Promx
HusqvarnaTC 85Intermediate30 min

Husqvarna TC 85: fork dust seal and oil seal cleaning

Dirt under the dust seal kills fork seals – regular cleaning extends their life.

The TC 85 fork seals are small and delicate – sand or dirt under the dust seal wears the seal out fast. Regular cleaning without disassembly is a cheap way to keep the suspension healthy.

Before you start

Safety: fork parts are spring-loaded and heavy – support the bike so the front wheel is free and the fork cannot unload accidentally. Use only manufacturer-approved products, as the wrong solvents can swell seals.

  • Put the bike on a stand and lift the front wheel clear.
  • Clean the fork tubes and the dust seal area.

Removing and cleaning the dust seal

  1. Pull the dust seal off the lower fork leg – it usually comes away carefully downwards.
  2. Wipe the inside of the seal and the tube surface clean.
  3. Check the oil seal: oil film or sticky dirt on it may mean it is already worn.

Cleaning the oil seal without disassembly

  1. Slide a thin plastic strip or a dedicated seal cleaner between the seal and the tube.
  2. Pull carefully upward and clear the trapped grit – do not push the tool too deep.
  3. Wipe the tube and inspect it: scratches or pitting eat seals.

Lubrication and refitting

  1. Apply a drop of fork oil or protective spray to the tube surface.
  2. Press the dust seal back into place.
  3. Pump the fork a few times and check there is no oil leak.

Tips

  • Clean regularly – after every ride on sandy tracks.
  • If the seal leaks or the tube is scratched, replacing the fork parts is the only lasting fix.
  • Record seal work and observed condition in the service log.

Read also

Husqvarna TC 85: fork dust seal and oil seal cleaning | Promx