Promx
HusqvarnaTC 85Easy25 min

Husqvarna TC 85: coolant change

Fresh coolant protects the engine from overheating – change it regularly.

Coolant ages and loses its corrosion protection and boiling point. Changing it on a TC 85 is a quick job worth doing yearly or at the start of the season.

Before you start

Safety: never open the cap on a hot engine – boiling coolant burns badly. Always use manufacturer-approved coolant; the wrong type can damage radiators and seals. Check the drain plug torque in the manual.

  • Let the bike cool completely.
  • Place a drain pan under the radiator.

Draining the old coolant

  1. Remove the filler cap at the radiator or top of the cover.
  2. Open the drain plug at the bottom or lower radiator edge.
  3. Let it drain fully – rock the bike side to side.

Refilling

  1. Refit the drain plug with a new washer.
  2. Pour coolant into the filler slowly using a funnel – avoid air pockets.
  3. Fill almost to the top, leaving a small air gap for expansion.
  4. Idle the engine for a couple of minutes and check the level – top up if needed.
  5. Refit the cap and wipe spills.

Check

  1. Check for leaks at the plug and hose joints.
  2. Do a short test ride and re-check the level once cold.

Tips

  • Use pre-mixed coolant or concentrate diluted with distilled water – tap water leaves scale.
  • Check the radiator fins and hose clamps at the same time.
  • Record the change in the service log.

Read also

Husqvarna TC 85: coolant change | Promx